Dishwasher Water Supply Through Floor

Adjust the leveling legs with a wrench until the dishwasher is perfectly level.

Dishwasher water supply through floor.

Then install 12 awg cable from the dishwasher space to the service panel. Then get on the floor to connect lines to the dishwasher. Connect the drain hose according to manufacturer s instructions. Extend the stainless steel braided water supply hose from the sink cabinet out to the dishwasher.

Leave about six feet of cable sticking through the hole by the dishwasher. 3 drill another 1 inch hole 6 inches below the hole for the hose to feed the copper tubing water supply line at the back of the. This valve can malfunction and fill the dishwasher with water when not in use. It can help to have a helper under the sink carefully feed the water supply tube and drain hose through the hole in the cabinet s side wall as you pull the appliance out from under the countertop.

The dishwasher is supplied with water from the water inlet valve. When enough water has filled the dishwasher the rising float switch is supposed to tell the dishwasher to stop the water flow. This will force water out of your dishwasher and on to your floor. Use a drill driver to screw the dishwasher s mounting tabs to the underside of the countertop.

The float switch is usually a plastic disc or cone that is attached to the floor of the dishwasher and is able to move up and down a few centimeters. To avoid scratching the floor lift slightly as you pull the dishwasher out of the cabinet. Grab a towel or mop and soak up any visible water on your floor. This might mean pulling the unit out from under the counter so you can get any water that has pooled beneath the dishwasher itself.

Tape the hose down to the floor with electrical tape. Connect the water supply line to the 90 degree fitting using pliers to ensure a tight fit. The moment you notice your dishwasher is or has leaked make sure to first turn off the dishwasher. Turn on the water supply inspect for leaks and tighten connections if necessary.

If you see water in the dishwasher when you are not using it check the water inlet valve for faults. Tip the dishwasher upright and slide it into its space. Carefully slide the dishwasher into place. Your unit may be taking in more water than it should and not draining properly.

This will allow the dishwasher to be pulled out during servicing. Replace the dishwasher s front panel. Drill the hole for the dishwasher drain hose at this location. You may be experiencing problems with the drain itself or the float valve isn t sealing properly.

If this valve is faulty the dishwasher can fill with water and overflow onto the floor.