6 with the fronts of the 2 covers facing together slide the covers onto the rod see figure c.
Double shower curtain rod installation instructions.
In this video we walk you through the steps in which you need to take to install your kenney double curtain rod in your home.
Attach the rod and brackets to the wall with the mounting hardware provided.
Install the first bracket by screwing it into place.
Lay the rod sections on the floor.
Spring loaded or spring tension shower curtain rods are a quick solution to getting your shower splash under control or brushing up a less than.
Verify that the rod sections are the proper length for your installation.
Using the hardware that is incl.
Rotate the wall plate until it fits flush with the end of the rod.
Straight double shower curtain rod installation 5.
For rods 84 and longer assemble with the connector piece.
Once level have an assistant mark where the rod intersects the other wall.
Then move on to the next hole repeating the same process.
Then install the rod and place a level across the length of the rod.
Gently tap the anchors into the pilot holes with a hammer.
Once you find the proper height level the shower rod.
Drill pilot holes for the wall anchors.
If there is a stud in your mounting location use wood screws to attach the wall brackets.
It may use spring loaded clips that fit into holes in the bracket or screws that secure the rod to the bracket.
X pilot hole anchor.
Hold it while you level the rod.
Extend the adjustable curved shower rod as needed until it is the correct length then install the other end of the rod into the bracket on the opposite wall.
Continue threading until all 12 rings have been threaded through all 12 holes.
There should be no gap between the base of the wall plate and the end of the rod.
How to install spring loaded shower curtain rods.
Install your brackets using these marks for a level rod.
Place the wall brackets onto the ends of the shower rod and tighten the set screws secure.
Before installing installation curved double shower curtain rod pencil level tape measure screwdriver drill hammer hacksaw drill bit 1.
If not trim with a hacksaw.
The method may vary by manufacturer.